[Network Control]; [Netwrok Status] - Panasonic PT-FZ570 Operating Instructions Manual

2) Press the <ENTER> button.
f The [PROJECTOR NAME] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f Up to eight characters can be input.
f Select [ALL DELETE] to delete all the entered characters, or press the <DEFAULT> button on the remote
control to delete a character on the cursor in the entry field.
4) Select [OK] with the as buttons and press the <ENTER> button.
f To cancel the change of the name, press asqw to select [CANCEL] and press the <ENTER> button.
Note
f [Name □□□□ ] ( □□□□ is 4-digit number) is set before the projector leaves the factory.

[NETWORK CONTROL]

Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
[PJLink CONTROL]
[COMMAND CONTROL]
[COMMAND PORT]
[Crestron Connected(TM)]
[AMX D.D.]
[EXTRON XTP]
4) Press as to select [OK], and press the <ENTER> button.
f The current network control settings is saved.

[NETWROK STATUS]

Display the status of the projector network.
1) Press as to select [NETWORK STATUS].
2) Press the <ENTER> button.
f The [NETWORK STATUS] screen is displayed.
f The display screen (1/2 [WIRED LAN] → 2/2 [WIRELESS LAN]/[Presenter Light]) will change each time you
press as .
[WIRED LAN]
[WIRELESS LAN]
Chapter 4 Settings — [NETWORK] menu
Set to [ON] to control with the web browser.
Set to [ON] to control with the PJLink protocol.
Set to [ON] to control with the <SERIAL IN> terminal control command format (x page 145). Refer
to "Control commands via LAN" (x page 142).
Set the port number used for command control.
Set to [ON] to control with Crestron Connected
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through "AMX Device Discovery". For details, refer to
the website of AMX Corporation.
URL http://www.amx.com/
Set to [ON] when connecting the "XTP transmitter" of Extron Electronics to the <DIGITAL LINK/LAN>
terminal.
The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G).
For details of the "XTP transmitter", refer to the website of Extron Electronics.
URL http://www.extron.com/
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
[MAC ADDRESS]
[SSID]
*1
[IP ADDRESS]
*1
of Crestron Electronics, Inc.
TM
Displays the usage state of the DHCP server.
Displays the IP address.
Displays the subnet mask.
Displays the default gateway.
Displays the address of the preferred DNS server.
Displays the address of the alternate DNS server.
Displays the MAC address.
Displays the character string of SSID.
Displays the IP address.
ENGLISH - 103