[Clock Phase]; [Over Scan]; [Aspect] - Panasonic PT-FZ570 Operating Instructions Manual

Attention
f Set it before adjusting [CLOCK PHASE].
Note
f Depending on the input signal, if the adjustment of [DOT CLOCK] exceeds the effective adjustment range of the input signal, the position of
the image cannot be changed. Please adjust [DOT CLOCK] within an effective adjustment range.

[CLOCK PHASE]

(Only for RGB signals and YC
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press as to select [CLOCK PHASE].
2) Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
3) Press qw to adjust.
f Adjustment value will change between [-16] and [+16]. Adjust so that the amount of interference is at a
minimum.
Note
f Certain signals may not be adjustable.
f Optimal value may not be achieved if the output from the input computer is unstable.
f To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is adjusted.
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.

[OVER SCAN]

(Only for movie-based RGB signals, YC
LINK signals, VIDEO signals and Y/C signals input)
Use this function when characters or pictures are cropped near the periphery of the projected image.
1) Press as to select [OVER SCAN].
2) Press qw or the <ENTER> button.
f The [OVER SCAN] individual adjustment screen is displayed.
3) Press qw to adjust the level.
f The adjustment values are [0] to [+3].

[ASPECT]

You can switch the aspect ratio of the image.
The aspect ratio is switched within the screen range selected in [SCREEN FORMAT] of [DISPLAY OPTION] menu
→ [SCREEN SETTING]. Set [SCREEN FORMAT] first. ( x page 81)
1) Press as to select [ASPECT].
2) Press qw or the <ENTER> button.
f The [ASPECT] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
*
[AUTO]
1
[WIDE]
[H FIT]
Chapter 4 Settings — [POSITION] menu
C /YP P signals input)
B R B R
C /YP P
B R B
Displays images without changing the aspect ratio of the input signals.
The aspect ratio is automatically switched to the optimum aspect ratio when an aspect ratio identifier is
included in the input signal.
Displays images with the aspect ratio converted to 16:9 when standard signals
Display images without changing the aspect ratio when wide-screen signals
Displays images using the entire width of the screen. When signals have the aspect ratio vertically longer than
the aspect ratio of the screen selected in [SCREEN FORMAT], the images are displayed with the top and the
bottom parts cut off.
signals, movie-based HDMI signals, movie-based DIGITAL
R
*
2 are input.
*
3 are input.
ENGLISH - 73