Projecting; Selecting The Input Signal - Panasonic PT-FZ570 Operating Instructions Manual

Projecting

Check the external device connection ( x page 36), power cord connection ( x page 41), and switch on the
projector ( x page 42) to start projecting. Select the image for projection, and adjust appearance of the projected
image.

Selecting the input signal

The input for projection can be switched. Method to switch the input is as follows.
f Press the input selection buttons on the remote control and directly specify the input to project.
f Press the <INPUT SELECT> button on the control panel to display the input selection screen and select the
input to project from the list.
Switching the input directly via remote control
The input for projection can be switched directly by pressing the input selection button on the remote control.
1) Press the input selection (<HDMI1>, <HDMI2>, <DIGITAL LINK>, <COMPUTER1/2>*
<NETWORK>) buttons.
f Switches the input, the input guide of the selected input terminal displayed on the top right of the projection
screen.
<HDMI1>
<HDMI2>
<DIGITAL LINK>
<COMPUTER1/2>
*1
<VIDEO>
<NETWORK>
*1 If the [DISPLAY OPTION] → [COMPUTER IN/OUT]→ [COMPUTER2 SELECT] is set to [COMPUTER1 OUT], the COMPUTER2 INPUT
cannot be selected.
Attention
f Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back. Set the [PICTURE]
menu → [RGB/YC C ]/[RGB/YP
B R
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT]. ( x page 73)
Note
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
f Configure [COMPUTER1 INPUT SETTING] of the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] ( x page 77) to match the signal
to be input to the <COMPUTER 1 IN> terminal.
f If input signal to the <COMPUTER 2 IN/1 OUT> terminal, please set [COMPUTER2 IN] of the [DISPLAY OPTION] menu → [COMPUTER
IN/OUT] → [COMPUTER2 SELECT].
Chapter 3 Basic Operations — Projecting
Remote control
Switches the input to HDMI1. The image of the signal being input in the <HDMI 1 IN> terminal is
projected.
Switches the input to HDMI2. The image of the signal being input in the <HDMI 2 IN> terminal is
projected.
Switches the input to DIGITAL LINK. The image of the signal being input in the <DIGITAL LINK/LAN>
terminal is projected.
Switches the input to COMPUTER1 or COMPUTER2. If one input is already selected, it will be
switched to the other input. The image of the signal being input in the <COMPUTER 1 IN> terminal or
the <COMPUTER 2 IN/1 OUT> terminal is projected.
Switches the input to VIDEO. The image of the signal being input in the <VIDEO IN> terminal is
projected.
Switches the input to NETWORK.
P ]. ( x page 65)
B R
Control panel
, <VIDEO>,
1
ENGLISH - 47