Adjusting Adjustable Feet - Panasonic PT-FZ570 Operating Instructions Manual

For PT-FX500
Screen height (SH)
Screen width (SW)
Minimum distance (LW)
Maximum distance (LT)

Adjusting adjustable feet

Install the projector on a flat surface so that the front of the projector is parallel to the screen surface and the
projected image is rectangular.
If the screen is tilted downward, the projected image can be adjusted to be rectangular by adjusting the front
adjustable feet. The adjustable feet can also be used to adjust the projector to be level when it is tilted in the
horizontal direction.
Extend the adjustable feet by rotating in the direction shown in the figure and retract by rotating in the opposite
direction.
Attention
f Heated air is expelled from the air exhaust port while the lamp is lit. Do not touch the air exhaust port directly when adjusting the adjustable
feet. ( x page 26)
Chapter 2 Getting Started — Setting up
4:3 aspect ratio
= 0.6 × SD
= 0.8× SD
= 1.0630 × SD - 0.0332
= 1.9706 × SD - 0.0334
16:9 aspect ratio
= 0.490× SD
= 0.872× SD
= 1.1581 × SD - 0.0332
= 2.1469 × SD - 0.0334
Maximum adjustable range
Adjustable feet: 23 mm (29/32") each
ENGLISH - 35