Setting Up; Installation Mode - Panasonic PT-FZ570 Operating Instructions Manual

Setting up

Installation mode

There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD]
( x page 88) depending on the installation method.
Mounting on the ceiling and projecting forward
Menu item
[PROJECTION METHOD]
Setting on a desk/floor and projecting forward
Menu item
[PROJECTION METHOD]
Note
f The projector has a built-in angle sensor. When projecting in front of the screen, if set the [PROJECTOR SETUP] menu
→ [PROJECTION METHOD] → [AUTO], the projector's posture will be detected automatically. When projecting from
rear, please set the [PROJECTION METHOD] to [REAR/DESK] or [REAR/CEILING].
rAngle sensor
The range of installation posture detected by the projector's built-in angle sensor is as follows.
In the case of [AUTO], when the projector is placed horizontally upright within ±150°, it will switch to [FRONT/
DESK]; when the projector is placed horizontally upside down within ±30°, it will switch to [FRONT/CEILING]
automatically. However, the setting range for [FRONT/DESK] is horizontally upright within ±30°.
[FRONT/DESK]
Attention
f The angle sensor cannot detect whether it is the "Installation prohibited posture" in the above picture. Please do not use the projector tilted
at an angle that exceeds ±30° from the vertical plane. It may reduce the life of the components. ( x page 18)
Chapter 2 Getting Started — Setting up
Method
[AUTO] or [FRONT/CEILING]
Method
[AUTO] or [FRONT/DESK]
150°
Installation
prohibited posture
30°
30°
Installation
prohibited posture
150°
：
Projection direction
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
30°
[FRONT/CEILING]
30°
Method
[REAR/CEILING]
Method
[REAR/DESK]
ENGLISH - 31