[Off] - Panasonic PT-FZ570 Operating Instructions Manual

3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation
Press the w button.
Press the q button.
Adjusting the left to right audio balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation
Press the w button.
Press the q button.
Setting audio output of the built-in speaker
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BUILT-IN SP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]

[OFF]

Note
f Audio is output from the built-in speaker even if the cable is connected to the <VARIABLE AUDIO OUT> terminal. To output audio from
external audio devices connected to the <VARIABLE AUDIO OUT> terminal and not from the built-in speaker, set [BUILT-IN SP] to [OFF].
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] ( x page 89), even if [IN STANDBY MODE] is set to [ON], audio
cannot be output during standby.
f When [IN STANDBY MODE] is set to [ON] and the digital signal is input, the audio output is interrupted during the cooling period after the
power is turned off, but this is not a malfunction.
92 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Adjustment
Increases the volume.
Decreases the volume.
Increases the volume on the right.
Increases the volume on the left.
Audio is output from the built-in speaker.
Audio is not output from the built-in speaker.
Disables audio output in the standby mode.
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this
time, press the <VOL-> button/<VOL+> button on the remote control or the control panel to adjust
the volume.
Adjustment
Range
0 ~ 63
Range of adjustment
L16 ~ R16