[Date And Time] - Panasonic PT-FZ570 Operating Instructions Manual

[COMMAND]
[INPUT]
[LAMP POWER]
[IN STANDBY MODE]
[VOLUME]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, it is disabled.
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen. Set
the time and the command again.
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. ( x page 96)
f If an operation is executed with the remote control or the control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.

[DATE AND TIME]

Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [TIME ZONE].
4) Press qw to switch [TIME ZONE].
Setting the date and time manually
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3) Press as to select [ADJUST CLOCK].
4) Press the <ENTER> button.
f The [ADJUST CLOCK] screen is displayed.
5) Press as to select an item, and press qw to set the local date and time.
6) Press as to select [OK], and press the <ENTER> button.
96 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
[NETWORK]
[COMPUTER1]
[COMPUTER2]
[HDMI1]
[HDMI2]
[VIDEO]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
*1
[NORMAL]
[ECO]
[OFF]
[ON]
[0] ~ [63]
Description
Switches the input to NETWORK.
Switches the input to COMPUTER1.
Switches the input to COMPUTER2.
Switches the input to HDMI1.
Switches the input to HDMI2.
Switches the input to VIDEO.
Switches the input to DIGITAL LINK.
Switches the input to DIGITAL LINK, and switch the input of the
Panasonic twisted-pair-cable transmitter to the specified input.
Sets the lamp brightness to high luminance.
Sets the lamp brightness to low luminance.
Audio output is stopped during standby.
Audio is output during standby.
Sets the volume.