Adjusting The Image - Panasonic PT-FZ570 Operating Instructions Manual

Switching the input by displaying the input guide
The input for projection can be selected by displaying the input guide with the control panel.
1) Press the <INPUT SELECT> button on the control panel.
f The [DETAILED] input guide or the [SIMPLE] input guide is displayed. ( x page 76)
2) Press the <INPUT SELECT> button again.
f The input will switch each time you press the <INPUT SELECT> button.
f You can also select the input source by pressing asqw on the remote control or the control panel from
the [DETAILED] input guide.
Note
f The input guide for [DETAILED]/[SIMPLE], you can change the setting from the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] →
[INPUT GUIDE].

Adjusting the image

Adjust the position, size and focus of the projected image.
Fig. 1
1) Adjust the projection angle.
f Install the projector on a horizontal location as the front surface of the projector is parallel to the screen
surface so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the
projected screen is rectangular.
f Refer to "Adjusting adjustable feet" ( x page 35) for details.
2) Release the lens shift lever lock by turning it counter-clockwise.
3) Adjust the lens shift. (Fig. 1)
f Adjust the projection position by using the lens shift lever.
f Refer to "Adjustment range by the lens position shift (optical axis shift)" ( x page 49) for details.
4) Lock the lens shift lever by turning it clockwise.
5) Adjust the zoom and focus. (Fig. 2)
f Adjust the projected image size by turning the zoom lever.
f Adjust the focus by turning the focus lever.
Note
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
48 - ENGLISH
Chapter 3 Basic Operations — Projecting
The input guide for [DETAILED]
Lens shift lever
The input guide for [SIMPLE]
If there is no signal input ([COMPUTER1],
[COMPUTER2], [HDMI1] or [HDMI2]), this
screen will be displayed. Check the output
settings of your computer.
Fig. 2
Zoom lever
Focus lever