Disassembly and Reassembly
6-2 FaxCentre F12
General Precautions on Disassembly
When you disassemble and reassemble components, you must use extreme caution.
The close proximity of cables to moving parts makes proper routing a must. If components are removed,
any cables disturbed by the procedure must be restored as close as possible to their original positions.
Before removing any component from the machine, note the cable routing that will be affected.
Whenever servicing the machine, you must perform the following:
1. Check to verify that documents are not stored in memory.
2. Unplug the power cord.
3. Use a flat and clean surface.
4. Replace only with authorized components.
5. Do not use force to remove the platen or plastic-material components.
6. Make sure all components are in their proper position when re-assembling.
6-24
3/03
WorkCentre Pro 412, FaxCentre F12 &
WorkCentre M15/M15i