Process; Ip Acl Cli Example - NETGEAR ProSafe FSM7328S Administration Manual
Managed switch
Hide thumbs
Also See for ProSafe FSM7328S:
- User manual (402 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
Process
To configure ACLs, follow these steps:
•
Create an ACL by specifying a name (MAC ACL) or a number (IP ACL)
•
Add new rules to the ACL
•
Configure the match criteria for the rules
•
Apply the ACL to one or more interfaces
IP ACL CLI Example
The script in this section shows you how to set up an IP ACL with two rules, one applicable to
TCP traffic and one to UDP traffic. The content of the two rules is the same. TCP and UDP
packets will only be accepted by the 7000 Series Managed Switch if the source and destination
stations have IP addresses that fall within the defined sets.
Figure 7-1
Access Control Lists (ACLs)
NETGEAR 7000 Series Managed Switch Administration Guide
v1.0, March 2006
7-3
Advertisement
Table of Contents
