port, and what is enabled or disabled on the port.
(Netgear Switch Routing) #show port 0/7
Intf
Type
1/0/7
Mirror
(Netgear Switch Routing) #show port 0/8
Admin
Intf
Type
Mode
----
----
------
1/0/8
Probe
Enable
Example #4: (Config) monitor session 1 mode
To set up port mirroring, specify the monitor session, then the mode.
(Netgear Switch Routing)(Config)#monitor?
session
Configure port mirroring.
(Netgear Switch Routing)(Config)#monitor session?
<1-1>
Session number.
(Netgear Switch Routing)(Config)#monitor session 1?
destination
Configure the probe interface.
mode
Enable/Disable port mirroring session.
source
Configure the source interface.
(Netgear Switch Routing)(Config)#monitor session 1 mode?
<cr>
Press Enter to execute the command.
(Netgear Switch Routing)(Config)#monitor session 1 mode
Port Mirroring
NETGEAR 7000 Series Managed Switch Administration Guide
Admin
Physical
Mode
Mode
Enable
Auto
Physical
Mode
--------
Auto
v1.1, May 2006
Physical
Link
Status
Status
Down
Physical
Link
Status
Status
--------
------
Down
Link
LACP
Trap
Mode
Enable
Enable
Link
LACP
Trap
Mode
----
----
Enable
Enable
15-3