Operation - Reloop RMP-3a Instruction Manual

INStaLLtION NOtES
A) Connect the Out Hub -42- to the line in hub of your mixing console or amplifier. Optionally, con-
nect the Digital Out Hub -43- with any device that features a digital in hub, such as a CD burner, MD
recorder, digital mixer or audio card.
B) Connect the Hub -45- to the line cord and your our outlet.
C) The Relay Play Connection -39- can be used for Relay Play as well as for the Fader Start function.
>>For more details go to item -39-.
D) Optionally, attach headphones to the 6.3mm stereo jack connection -40-. Use the Control Button
-41- to set the volume.
E) After making all connections, switch the device on using the ON/OFF Switch -44-. If no CD is in
the drive, the Status LED above the drive -1- is continually illuminated.
F) Gently slide a CD with the picture facing upwards into the slot -1-. The CD is automatically pulled
in. When playing a CD with a diameter of less than 12 cm, use any conventional adapter. Press the
Eject -19- button while in Pause/Cue mode to eject the CD.

OpEratION

1. CD Drive
For information regarding the drive, please refer to the above installation notes.
>> see F
2. play/pause Button
Press the Play/Pause Button -2- to start play mode. Press again to activate Pause mode.
NOtE:
your CD player goes into auto-Cue mode after being switched on.
>> see also item 8 or item 11/O.
In this DJ-friendly mode, the Cue Point is automatically set on the first signal of a music track.
3. Cue Button
A Cue Point is a self-defined starting point, usually at the beginning of a beat. When activating the
Cue Button -3- the CD player interrupts playing the track and returns to the last set Cue Point. To
set a Cue Point, follow either of the following two options:
I.) Search the desired Cue Point using the Jog Wheel -18- or the Search Wheel -5- while in Pause
mode. You will access the Frame Search mode (fragmented repeats =1/75 minute) and can precisely
set your Cue Points. Then press the Play/Pause Button -2- to save the Cue Point. The player returns
to Play mode.
II.) While in Play mode, press the Loop In Button -12- at the desired point to save the Cue Point. The
player remains in Play mode. With a little practice, this is a faster way to set the desired Cue Point.
Press the Cue Button -3- for the player to return to the Cue Point and go into Pause mode. By pres-
sing and holding the Cue Button you will return to Play mode until you release the button again. The
player will then return to the Cue Point and go into Pause mode. Press the Play/Pause Button -2- to
permanently return to Play mode.
31