Connecting Your G.shdsl Modem Router - NetComm G.SHDSL 4-port Security Modem Routers NB712 User Manual

5 Connecting your G.SHDSL Modem Router

This guide is designed to lead users through the Web Configuration of the G.SHDSL Modem Router in the easiest
and quickest way possible. Please follow the instructions carefully.
Note: There are three methods to configure the router: serial console, Telnet and Web
Browser. Only one configuration application is used to setup the Modem Router at
any given time. Select the method you wish to use and continue.
For Web configuration, you can skip step 3.
For Serial Console Configuration, you can skip step 1 and 2.
Step 1: Check the Ethernet Adapter in PC
Make sure that an Ethernet Adapter has been installed in the PC that is to be used for configuration of the router.
TCP/IP protocol is necessary for web configuration, so please check that the PC has TCP/IP protocol installed.
Step 2: Check the Web Browser in PC
For Web Configuration, ensure that the PC has a Web Browser installed, such as IE or Netscape.
Note: Suggest IE5.0, Netscape 6.0 or above and 800x600 screen resolution or above.
Step 3: Check the Terminal Access Program
For Serial Console and Telnet Configuration, users need to setup the terminal access program with VT100
terminal emulation.
Step 4: Determine Connection Setting
Users need to know the Internet Protocol supplied by your Service Provider and determine the mode of setting.
Protocol
RFC1483
RFC1577
RFC2364
RFC2516
Different Protocols are required to setup different WAN parameters. Your ISP will advise the correct protocol and
the necessary WAN parameters to configure your Modem Router.
16
Selection
Ethernet over ATM
Classical Internet Protocol over ATM (CLIP)
Point-to-Point Protocol over ATM (PPPoA)
Point-to-Point Protocol over Ethernet (PPPoE)
NB712 / NB714 User Guide
YML829 Rev1