Configuration - NetComm G.SHDSL 4-port Security Modem Routers NB712 User Manual

14.7 Configuration
To setup the router, move the cursor " >>" to Enable and press the enter key. When the screen appears, type the
supervisor password. The default supervisor password is admin. The password will be prompted as a " * " symbol
for system security.
----------------------------------------------------------------------
Command: enable <CR>
Message: Please input the following information.
Supervisor password: ****
----------------------------------------------------------------------
In this sub menu, you can setup management features and upgrade software, backup the system configuration
and restore the system configuration via utility tools.
Any changes will need to be written to EPROM and the router will need to be rebooted to work with the new
settings.
The screen will prompt as follow.
>> enable
setup
status
show
write
reboot
ping
admin
utility
exit
The description of the commands are:
Command
enable
setup
status
show
write
reboot
NB712 / NB714 User Guide
YML829 Rev1
Modify command privilege
Configure system
Show running system status
View system configuration
Update flash configuration
Reset and boot system
Packet internet groper command
Setup management features
TFTP upgrade utility
Quit system
Description
Modify command privilege. When you login via serial
console or Telnet, the router defaults to a program execution
(read-only) privileges. To change the configuration and write
changes to nonvolatile RAM (NVRAM), you must work in
enable mode.
To configure the product, you have to use the setup
command.
View the status of product.
Show the system and configuration of product.
Update flash configuration. After you have completed all
necessary settings, write the new configuration to NVRAM
by the "write" command and reboot the system, or all of your
changes will not take effect.
Reset and boot system. After you have completed all
necessary changes, write the new configuration to NVRAM
and reboot the system by "reboot" command, or all of your
changes will not take effect.
85