Utility; Exit; Setup - NetComm G.SHDSL 4-port Security Modem Routers NB712 User Manual

14.14 Utility

There are three utility tools, upgrade, backup and restore, embedded in the firmware. You can update the new
firmware via TFTP upgrade tools and backup the configuration via TFTP backup tool and restore the configuration
via TFTP restore tool. For upgrade, TFTP server with the new firmware will be supported by supplier but for
backup and restore, you must have your own TFTP server to backup and restore the file.
Move the cursor " >> " to utility and press enter.
>> upgrade
Upgrade main software
backup
Backup system configuration
Restore
Restore system configuration

14.15 Exit

If you want to exit the system without saving, use exit command to quit system.

14.16 Setup

All of the setup parameters are located in the subdirectories of setup. Move the cursor " >> " to setup and press
enter.
>> mode
shdsl
wan
bridge
vlan
route
lan
ip_share
firewall
dhcp
dns_proxy
hostname
default
14.16.1 Mode
The product can act as routing mode or bridging mode. The default setting is routing mode. You can change the
system operation mode by using mode command. Move the cursor " >> " to mode and press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>: Route
----------------------------------------------------------------------
NB712 / NB714 User Guide
YML829 Rev1
Switch system operation mode
Configure SHDSL parameters
Configure WAN interface profile
Configure transparent bridging
Configure virtual LAN paramters
Configure routing parameters
Configure LAN interface profile
Configure NAT/PAT parameters
Configure Firewall parameters
Configure DHCP parameters
Configure DNS proxy parameters
Configure local host name
Restore factory default setting
95