Moving System Board Jumpers - NEC EXPRESS5800/120Ed User Manual

Jumper Function
1 - 2 CMOS clear
3 - 4 Password disable
5 - 6 Reserved
7 – 8 Reserved
9 – 10 Reserved
11 - 12 Spare

Moving System Board Jumpers

Before doing the procedures in this section, make sure that
your system is powered off and unplug the AC power cords
from the back of the chassis. Failure to disconnect power
before moving the jumpers can result in personal injury and
equipment damage.
Observe static precautions. Use an antistatic wrist strap.
To configure the system board options:
1. Power off the system and remove the left panel as described in Chapter 4 of
this guide.
2. Check to ensure the system power cord is removed from the back of the
system.
3. Locate the position of the jumpers on the system board you are changing.
See Figure 3-1. To change a jumper setting, use a pair of needle-nose pliers
or your fingers to remove the jumper from its current location. Position the
jumper over the two pins for the desired setting and press it onto the pins. Be
careful not to bend the pins. Refer to Table 3-3 for system board jumper
settings.
4. Install the system cover and power up the system.
3-20 Configuring Your System
Table 3-3. System Board Jumper Summary
Jumper On/Off
(default in bold)
Off, Protect
On, Erase
Off, Enable
On, Disable
Off, Not Used
Off, Not Used
Off, Not Used
Off, Not Used
On, Spare
! CAUTION
What it does at system reset.
Preserves the contents of CMOS.
Clears CMOS.
Enables password protection.
Disables the password.
Required. Do Not Change.
Required. Do Not Change.
Required. Do Not Change.
Provides a spare jumper.