Post Error Codes And Messages - NEC EXPRESS5800 LC1400 series User Manual

POST Error Codes and Messages

Whenever a recoverable error occurs during POST, BIOS displays a message on the
video display screen and causes the speaker to beep as the message appears. The
"POST Error Codes and Messages" table is a list of the error codes and messages
written at the start of each POST test.
Code Error Message
0162 BIOS unable to apply BIOS update to processor 1
0163 N/A
0164 BIOS does not support current stepping for processor 1
0165 N/A
0200 Failure Fixed Disk
0210 Stuck Key
0211 Keyboard error
0212 Keyboard Controller Failed
0213 Keyboard locked - Unlock key switch
0220 Monitor type does not match CMOS - Run SETUP
0230 System RAM Failed at offset
0231 Shadow RAM Failed at offset
0232 Extended RAM Failed at offset
0250 System battery is dead - Replace and run SETUP
0251 System CMOS checksum bad - Default configuration used
0260 System timer error
0270 Real time clock error
0297 ECC Memory error in base (extended) memory test in Bank xx
02B2 Incorrect Drive A type - run SETUP
02B3 Incorrect Drive B type - run SETUP
02D0 System cache error - Cache disabled
02F5 DMA Test Failed
02F6 Software NMI Failed
0401 Invalid System Configuration Data - run configuration utility
None System Configuration Data Read Error
0403 Resource Conflict
0404 Resource Conflict
5-20 Problem Solving
POST Error Codes and Messages