Special Functions; Always Open" Function; Move Anyway" Function; Connection Of Other Devices - Nice Spin10KCE Instructions And Warnings For The Fitter

7.4) Special functions

7.4.1) "Always open" Function

The "Always open" function is a control unit feature which enables
the user to control an opening manoeuvre when the "Step-by-step"
command lasts longer than 3 seconds. This is useful for connecting
a timer contact to the "Step-by-step" input in order to keep the door

7.4.2) "Move anyway" Function

If one of the safety devices are out of order or malfunctioning, it is still
possible to control the door in "Man present" mode.
Please refer to the Paragraph "Control with safety devices out of

7.5) Connection of other devices

If the user needs to feed external devices such as a proximity read-
er for transponder cards or the illumination light of the key-operated
selector switch, it is possible to tap power as shown in Figure 42.
The power supply voltage is 24Vac -30% +50% with a maximum
available current of 100mA.

7.6) Troubleshooting

The following table contains instructions to help you solve malfunc-
tions or errors that may occur during the installation stage or in case
of failure.
Table 21: Troubleshooting
Symptoms
The radio transmitter does not control the
door and the LED on the transmitter does
not light up
The radio transmitter does not control the
door and the LED on the transmitter lights up
No manoeuvre starts and the OK LED fails
to flash
No manoeuvre starts and the flashing light is
off
No manoeuvre starts and the flashing light
flashes a few times
The manoeuvre starts but it is immediately
followed by a reverse run
open for a certain length of time, for example. This feature is valid
whatever the "Step-by-step" input programming may be (see the
"Step-by-step" properties in table 17).
order" in the enclosure "Instructions and Warnings for users of the
SPIN gearmotor".
42
43
Probable cause and possible solution
Check to see if the transmitter batteries are exhausted, if necessary replace them
Check to see if the transmitter has been memorised correctly in the radio receiver.
Check that the emission of the transmitters radio signal is correct by means of this empiri-
cal test: push a key and rest the LED on the aerial of a normal radio (ideally an economical
one) that is switched on and tuned in, as close as possible, to 108.5Mhz FM; a slight
crackling sound should be heard.
Check that SPIN is being fed 230 V voltage from the power supply. Check to see if the
fuses F1 and F2 are blown; if necessary, identify the reason for the failure and then replace
the fuses with others having the same current rating and characteristics.
Make sure that the command is actually received. If the command reaches the Step-by-
Step input, the OK led flashes twice indicating that the command has been received.
Count the flashes and check the corresponding value in table 22.
The selected force could be too low for this type of door. Check to see whether there are
any obstacles; if necessary increase the force.
24Vac
F2
F1
GB
23