Examples Of Level 2 Programming - Nice Spin10KCE Instructions And Warnings For The Fitter

7.2.6) Examples of LEVEL 2 programming

This example shows the sequence of operations required to change the factory setting of the parameters and set the functions of "Belt
Recovery" to no recovery (input on L2 and level on L1) and set "Closing slowdown" to long (input on L3 and level on L3).
Table 20: Example of LEVEL 2 programming in "Programming on power-up" mode
1. Switch off SPIN (for example by removing fuse F1)
2. Press and hold [Set]
3. Switch on SPIN (for example by inserting fuse F1)
4. Wait for the flashing signal indicating control unit start-up and keep [Set] pressed until L1 starts to flash
(approx. 6s)
5. Release [Set]
6. Press the key [
7. Press and hold [Set] during steps 8 and 9
8. Wait approx. 3s until led L2 lights up, indicating the current level of "Belt recovery"
9. Press the key [
10. Release [Set]
11. Press the key [
12. Press and hold [Set] during steps 13 and 14
13. Wait approx. 3s until led L2 lights up, indicating the current level of "Closing slowdown".
14. Press the key [
"Closing slowdown".
15. Release [Set]
16. Wait 10s to exit the programming mode automatically after the maximum time interval.
This example shows the sequence of operations required to change the factory setting of the parameters and set the functions of "Motor
Force" to high (input on L1 and level on L3) and increase the "Pause Time" to 60s (input on L3 and level on L3).
Table 20a: Example of LEVEL 2 programming in "Standard programming" mode
1. Press and hold [Set] for approx. 3s
2. Release the key [Set] when led L1 starts to flash
3. Press and hold [Set] during steps 4 and 5
4. Wait approx. 3s until led L2 lights up, indicating the current level of "Motor Force"
5. Press the key [
6. Release [Set]
7. Press [ ] twice to move the flashing led onto led L3
8. Press and hold [Set] during steps 9 and 10
9. Wait approx. 3s until led L2 lights up, indicating the current level of "Pause Time".
10. Press the key [
11. Release [Set]
12. Wait 10s to exit the programming mode automatically after the maximum time interval.
20
] once to move the flashing led onto led L2
] once to move the illuminated led onto L1, to eliminate "Belt recovery"
] once to move the flashing led onto led L3
] once to move the illuminated led onto L3, indicating the new value of
] once to move the illuminated led onto L3, indicating the new value of "Motor Force"
] once to move the illuminated led onto L3, indicating the new value of "Pause Time".
Example
SET
L1 SET 6s
SET
L2
SET
L2 3s
L1
SET
L3
SET
L2 3s
L3
SET
10s
Example
3s
SET
L1
SET
SET
L2 3s
L3
SET
L3
SET
L2 3s
L3
SET
10s