Table of Contents
Advertisement
Front cover / Maintenance cover
Opening/closing the front cover
• Keep the front cover closed during plotting operation. Opening the front
cover during plotting interrupts image plotting and disables continuous
processing.
• Open and close the front cover while holding the handles. Doing so while
holding the resin face may cause damage to the device.
If you open the front cover during plotting, the carriage will stop for safety, resulting in abortion of
plotting. In this case, re-start the device and computer following the procedure described below.
STEP
1. When opening the cover during plotting, the
message shown on the right will be displayed.
Stop the drawing.
2. Stop the data transmission from the computer.
3. Close the front cover.
4. Push the [ENTER] key.
5. The carriage will start to move.
The carriage will carry out a series of performance same as
that taken after turning on the power to the device (i.e., the
predetermined initial performance).
Cautions on maintenance cover
• This cover enables to perform a ease head cleaning. Normally, plot opera-
tion cannot be performed without the maintenance cover for the cover pro-
tects the monitor and other parts of the device.
• Make sure to attach the maintenance cover at the appropriate location
before plotting.
• When attaching the maintenance cover, the same message appears on the
panel as the front cover.
page 2.3
- 2.4 -
Close a cover
( C O V E R O P E N )
PRESS < ENT > KEY
INITIALIZING
PLEASE WAIT
Advertisement
Table of Contents
