kozy heat Alpha ALP-36-L Installation And Operation Manual page 37

LOW BATTERY DETECTION
TRANSMITTER: Remote control battery lifespan depends on various factors including battery quality, number of ignitions, changes to
room thermostat set point, etc.
When transmitter batteries are low, a Battery Icon will appear on the LCD display before all battery power is lost. When batteries are
replaced this icon will disappear.
RECEIVER: Receiver battery lifespan depends on various factors including battery quality, number of ignitions, changes to room
thermostat set point, etc.
When receiver batteries are low, no 'beep' will be emitted from Receiver when it receives an ON/OFF command from the Transmitter. This
is an alert for a low battery condition for the Receiver. When the batteries are replaced the 'beep' will be emitted from the Receiver when
ON/OFF Key is pressed.
Figure 36a
MANUAL BYPASS OF REMOTE SYSTEM
If batteries of the Receiver or Transmitter are low or depleted, the appliance can be turned on by sliding the three position slider switch on
the Receiver to the ON position. This will bypass the remote control feature of the system and the appliance main burner will come on if
gas valve is in the ON position.
CONTINUOUS PILOT OPTION
This system has the option of a continuous (standing) pilot feature. This allows you to change from a spark-to-pilot system to a standing
pilot system during cold weather conditions. By having the pilot on continuously, the firebox will remain warm and a draft is established in
the vent, allowing the main burner to turn on with less air-flow disruption.
When continuous pilot mode is activated and fireplace is turned ON, the pilot will spark and light. When fireplace is turned OFF, the
pilot will remain lit when main burner has been turned OFF.
DIRECT FIREPLACE OPERATION
The fireplace may be directly operated from the receiver.
ON: Fireplace burner turns on (regardless of transmitter settings).
OFF: Fireplace burner turns off (regardless of transmitter settings).
REMOTE: Fireplace is controlled by remote control (transmitter).
When receiver switch is turned to ON or Off, mode settings (Accent Lights, Fan, Flame Height, Smart Thermostat) will remain
NOTE in same state as before switch was moved. If you wish to adjust mode settings use transmitter mode button to adjust settings.
The thermostat and burner ON/OFF operating functions will not work on the transmitter.
SYSTEM OPERATION
36