Xycom 4115T User Manual page 64

4115T Light Duty Industrial PC
Error Messages
SYSTEM HALTED, (CTRL-ALT-
DEL) TO REBOOT ...
WRONG BOARD IN SLOT
PLEASE RUN EISA
CONFIGURATION UTILITY
FLOPPY DISK(S) FAIL (80)
FLOPPY DISK(S) FAIL (40)
HARD DISK(S) FAIL (80)
HARD DISK(S) FAIL (40)
HARD DISK(S) FAIL (20)
HARD DISK(S) FAIL (10)
HARD DISK(S) FAIL (08)
MANUFACTURING POST LOOP.
BIOS ROM CHECKSUM ERROR -
SYSTEM HALTED.
MEMORY TEST FAIL.
Cause/Solution
The present boot attempt has been aborted and the system must be
rebooted. Press and hold down the CTRL and ALT keys and press DEL.
The board ID does not match the ID stored in the EISA non-volatile memory.
When this error appears, the system will boot in ISA mode, allowing you to
run the EISA Configuration Utility.
Unable to reset floppy subsystem
Floppy type dismatch
HDD reset failed
HDD controller diagnostics failed
HDD initialization error
Unable to recalibrate fixed disk
Sector Verify failed
System will repeat POST procedure infinitely while the P15 of keyboard
controller is pulled low. This is also used for M/B burn in test.
The checksum of ROM address F0000H-FFFFFH is bad.
BIOS reports the memory test failed if the onboard memory is tested error.
60
Appendix C – Power-On Self-Test Messages
143926(A)