Setting The Reception Mode; Volume Settings (Machine) - Sharp UX-D1200SE Operation Manual

Setting the Reception Mode

The machine has three modes for
receiving incoming faxes:
AUTO mode:
The machine automatically answers all
calls on 4 rings and begins fax
reception.
MANUAL mode:
All calls, including faxes, must be
answered by picking up the
machine's handset or an extension
phone connected to the same line.
TEL/FAX mode:
The machine automatically answers all
calls on 2 rings. If the machine detects
that a call is a voice call (including a
manually dialed fax), it makes a special
ringing sound to alert you to answer. If
the machine detects that the call is an
automatically dialed fax, it begins
reception automatically.
To set the reception mode, make sure a
document is not loaded in the
document feeder, and then press
RESOLUTION/
RECEPTION MODE
until the desired mode
appears in the display.
For more information on receiving
faxes, see Chapter 5.
Setting the Reception Mode

Volume Settings (Machine)

Speaker volume
SPEAKER
1
Press .
2
Press or
, or
MIDDLE LOW
SPEAKER
•
Press again to turn off the
speaker.
Handset receiver volume
1
When talking through the handset,
press or
, or .
MIDDLE LOW
•
The volume reverts to
time you replace the handset.
•
During an intercom call, to optimize
the volume of the machine handset
and cordless handset, the volume
setting indicated in the display may
correspond to a different volume
level than for a regular call.
Ringer volume
1
Press or
, , or
MIDDLE LOW
SPEAKER
has not been pressed, the
handset is not lifted, and a
document is not loaded in the
feeder.)
•
The ringer will ring once at the
selected level.
2
If you selected " OFF OK ?
off the ringer, press
to select ,
HIGH
.
to select ,
HIGH
each
MIDDLE
to select ,
HIGH
. (Make sure
OFF
" to turn
.
17