Forward/Reverse Switch; Neutral Adjustment - Jacobsen Sand Scorpion Safety And Operation Manual

6.8 FORWARD/REVERSE SWITCH _______________________________________________

(neutral adjustment)

If error codes "-02" or "-03" occur repeatedly the forward/
reverse switch for the traction controller could be out of
.
adjustment
!
WARNING
Turn power off, remove key and disconnect the battery
connector before inspecting or working on or near the
electrical system.
To adjust forward/reverse switch:
1. Lift hood and remove top cover from electrical box.
2. Operate forward/reverse pedals and check that
cable linkage is operating smoothly. If cable is
binding, or linkage is bent or damaged, contact an
authorized Jacobsen Distributor for repairs.
3. Remove screw (E) holding cable end to forward/
reverse switch lever.
4. Back off nut (F) which secures rod end (H) to cable.
5. With the cable disconnected, the switch lever (G)
should return to its neutral position. Adjust rod end
on cable so it aligns directly with hole in lever.
Note: If the alignment appears correct but the error
code continues to occur, the forward/reverse switch
may be faulty. Contact an authorized Jacobsen
Distributor for repairs.
MAINTENANCE & ADJUSTMENTS
6. Tighten jam nut to secure adjustment and reconnect
7. Start tractor and check that unit starts and operates
!
G
rod end to switch lever.
correctly.
H
E F
6
TR014
Figure 6B
GB-27