Eiki EK-501W Owner's Manual page 63

Description on network control operation
Network control operation
Function: This function is designed to remote control computer in the same LAN.
Preparation
1 Required equipment: Projector, connection, network cable
2 Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network
cable. In case a normal network cable failed to connect successfully, use a jumper cable
instead.
3 Turn on the computer. The LAN port and computer port of your projector flashes after it is
powered on.
Operation steps
1 Power on your projector.
2 Acquire the IP address, with DHCP set to on and auto IP allocation set to On. (You
may set DHCP to Off and set up IP address manually if you are somehow familiar with
networking.)
3 Enter the network setup menu
(1) Press MENU button on remote
controller or top of the control panel,
press
icon.
(2) Press ENTER button or
the network menu displays.
(3) Press
settings and press ENTER to
confirm.
(4) Press
and press OK button to confirm.
(5) Press
OK button to wait until the "Please
wait.." message disappears.
button to select network
button and
button select network
button to set DHCP On
button to select Set, press
Network
设置
Network setting
Network information
Network
Network setting
Network information
LAN Network setting
DHCP Off
IP address 192 . 168 . 1 . 100
Subnet 255 . 255 . 255 .
Gateway 192 . 168 . 1 .
DNS 192 . 168 . 1 .
Set
0
1
1
Cancel
63