System Selection - Eiki EK-501W Owner's Manual

Input source (Computer signals)

System selection

The scanning system and auto computer adjustment function may detect scores of signal format.
If a PC is selected as the input signal source, your projector will detect and adapt to its signal for-
mat automatically. Correct image can be displayed without any setup operation.
Your projector will display one of the following:
If your projector failed to identify
Auto
signals not shown in the signals
format table, the "Auto" message
will display in the System Signal
Format menu. The Auto PC Ad-
justing function will make neces-
sary adjustment to your projector
to project valid images. If images
are displayed incorrectly, adjust it
manually.
No PC signals detected. Check
-----
the connection between PC and
your projector.
Select the computer system manually.
1 Press the MENU button on remote control-
ler and the OSD displays. Press
to point to the Input icon, press
OK button and the Input menu displays.
2 Press button to select System Signal
Format, then press OK button.
3 Press button to select required system
signal format, then press OK button to con-
firm your selection.
Note:
The computer system menu will be disabled once HDMI or DVI has been selected.
OSD menu
HDMI
DVI
VGA
Component
S-video
Video
RGBHV
System
The selected system displays in the
PC system menu.
Note:
button
Your projector may save data gen-
button or
erated by the Auto PC Adjusting
function.
Input 设置
Auto
37