Screen Size Adjustment - Eiki EK-501W Owner's Manual

Input source (Computer signals)

Screen size adjustment

Your projector comes with screen size adjustment function for you to display required image size.
1 Press the MENU button on remote controller and the OSD displays. Press
Screen icon, press
2 Press button to point to required item and press OK button to confirm your selection.
Normal
This function keeps aspect ratio of the projected
image consistent with its input source.
True
Display image in its original size. If the orig-
inal size of a image is greater than screen
image of your projector (XGA:1024x768/
WXGA:1280x800), the later enters the Image
Display Area Selection mode. Press
button to select image display area. The arrow
mark turns red during adjusting. It disappears
when the adjustment limit is reached.
Wide
Provide image in aspect ratio of 16:9 by ex-
panding image width proportionally.
Full
Project image in full screen.
Custom
Adjust screen aspect ratio and position manu-
ally. Press button in customization area and
Custom options display. Press
select required items.
Horizontal ratio / Vertical ratio:
Adjust horizontal and vertical screen ratio.
Horizontal and Vertical:
The aspect ratio option will be disabled when
the horizontal and vertical screen ratio is set
to On. The vertical ratio option dims and ap-
pears unavailable. Adjust the horizontal ratio
and the screen size is adjusted according to
the aspect ratio.
Horizontal position / Vertical position:
Adjust horizontal / vertical position of image.
Note:
● Your projector does not support resolution greater than 1920x1200. For computer display of res-
olution greater than 1920x1200, downgrade it before connecting to your projector.
● Image data other than physical resolution will be modified to fit screen size give in reset mode.
● Option True, Full Screen, and Digital Zoom will be unavailable if no signals is detected in the PC
system menu.
42
button or OK button to confirm your selection.
button to
Normal
True
Wide
Full
Custom
Digital zoom +
Digital zoom -
Common: Save adjustment ratio applicable with
all input. Point to common and press
OK button to display a confirm menu.
Press Yes then OK to save your ratio
settings. The saved ratio will be used
when Custom is selected by user.
Reset: Reset your adjustments to its initial status.
Point to Reset and press OK to display a
confirm menu. Press OK to reset.
Digital Zoom +
Select Digital Zoom +. The OSD is replaced by
the Digital Zoom + message. Press OK button to
zoom in.
Press button to span the image. This
function is available only when the image is of
size greater than the screen.
Digital Zoom –
Select Digital Zoom –. The OSD is replaced by
the Digital Zoom – message. Press OK button to
zoom out.
Press any key, except the OK one, to exit the
Digital Zoom mode.
To reset to original screen size, select Screen
size in the Screen Size Adjustment menu, select
Input again in the Input menu, or press OK button
to adjust its size.
button to select
设置 Screen