Basic Operation; Power On Your Projector - Eiki EK-501W Owner's Manual

Power on your projector

1. Connect all external equipment to your projector (e.g. computer or camera) before powering it on.
2. Connect AC power cord of your projector to an AC power socket. The Power indicator turns on in
red.
3. Press the Power button on the rear control panel or the remote controller.
The Power indicator lights in green and the cooling fan starts running.
4. If your projector is setting as password protected, the password dialog box displays. Enter your
password as instructed below.
Enter password (PIN)
Press button to select a number, press
typed is displayed as " ". To edit number you have entered, press
number you want to change, press
Repeat this step to type in a 3-digit number.
Move the cursor to OK after you have typed
the 3-digit number. Press the ENTER button
and now you are ready to use your projector.
If the password is invalid, the password dis-
played as " " will be in red. Please try again
with a valid one.
What is a password (PIN)?
A password (PIN) is an ID code for identifying people with knowledge about it to oper-
ate your projector. A password (PIN) setting may help preventing your projector from
unauthorized use.
You password (PIN) code is a 3-digit number. To find out more about protecting your
projector with a password (PIN), please refer to the PIN Code Lock function in the
Setup menu on Page 54 for details.
Precautions on password (PIN) operation
You cannot operate a password (PIN) protected projector without correct password
(PIN) Please set up a new password (PIN) and keep your operation manual in safe
place. In case the password (PIN) is lost or forgotten, call your dealer or service center.
28

Basic operation

VOL-
button to enter it and move the cursor. The number you
button to select the correct one.
VGA
Power
IN
MONITOR OUT
VIDEO S-VIDEO AUDIO AUDIO
VOL+
IN1 OUT
360.2
button to move the cursor to the
Note:
● In case the "Logo Select" option is set
to OFF, then no welcome image will
display in screen.
● You can do nothing but powering off
your projector during the welcome
image is displaying.
P/PR G/Y B/PB H/HV V
AUDIO RS-232C R/C R/C
IN2 IN OUT
Power
DVI-D
AUDIO