Note About Matrox Meteor-Ii /Multi-Channel For Pc/104-Plus - Matrox Meteor-II Installation And Hardware Reference Manual

20 Chapter 2: Hardware installation
In some cases, when you boot your computer, Windows' Plug-and-Play system
will detect a new PCI card and you will be asked to assign a driver to it. At this
point, you should click on Cancel because the driver will be installed during the
installation of MIL or one of its derivatives.
Note about Matrox Meteor-II /Multi-Channel
for PC/104-Plus
A version of the Matrox Meteor-II /Multi-Channel for PC/104-Plus accompanies
the Matrox 4Sight-II integrated unit. It differs slightly in its structure from its
stand-alone counterpart. The stand-alone version of the Matrox Meteor-II for
PC/104-Plus has a video input connector that lies in the same plane as the board
(in other words, the pins are parallel to the board). The version that accompanies
the Matrox 4Sight-II integrated unit lies in a plane perpendicular to the board.
The latter allows the Matrox Meteor-II board to be hardwired to the input
connector of the Matrox 4Sight-II unit; as such, it can only be used as the first
board in the PC/104-Plus stack on the Matrox 4Sight-II unit.
Matrox Meteor-II for PC/104-Plus frame grabber (inverted view)
Video Input connector
pins for Matrox Meteor-II
For Matrox 4Sight
When ordered as part of the Matrox 4Sight-II unit, Matrox Meteor-II for
PC/104-Plus comes pre-installed. See the Matrox 4Sight-II installation and
hardware reference manual for more information.
Video Input connector
pins for Matrox Meteor-II
Stand-alone version