Matrox Meteor-Ii /Multi-Channel For Pc/104-Plus - Matrox Meteor-II Installation And Hardware Reference Manual

Matrox Meteor-II /Multi-Channel for PC/104-Plus

Matrox Meteor-II /Multi-Channel for PC/104-Plus has four connectors, which
are indicated in the diagram below. The video input connector is discussed in
detail in Appendix B.
• Video input connector. A connector used to receive analog video, as well as send
and receive synchronization signals and power.
• PC/104-Plus (PCI) connector. An interface connector to send data across the PCI
bus.
• PC/104 (ISA) connectors. Two interface connectors to send data across the ISA
bus.
Plus
PC/104-
(PCI)
connector
Connecting a video input to Matrox Meteor-II /Multi-Channel for
PC/104-Plus
Connect video sources to Matrox Meteor-II /Multi-Channel through its video
input connector, a 30-pin right-angle male connector. A standard cable for
PC/104-Plus form factor boards is not available from Matrox. You can use the
included mating connector, crimp the ribbon cable to it and attach your required
connector to the other end of the ribbon cable. Then, connect this custom cable
to the video input connector. See Appendix B for the pinouts, signals, and ribbon
cable information for the /Multi-Channel board.
Connecting external devices
P2
P1
Video input
connector
23
PC/104
(ISA)
P1 and P2
connectors