Matrox Meteor-II Installation And Hardware Reference Manual page 47

Pin Signal
41 VID2_IN2
40 VID2_IN3
35 OPTOTRIG+
34 OPTOTRIG-
20 TRIGGER
19 CLK_IN_TTL
33 CLK_OUT_TTL
32 VSYNC_TTL
2 HSYNC_TTL
38 EXP(1)
23 EXP(2)
36 TX
22 RX
6 CTS
21 RTS
39 USER1IN+
12 USER1IN-
9 USER2IN+
10 USER2IN-
24 USER1OUT
8 USER2OUT
1, 16 DC POWER
7, 37 NC
3-5, 14, 17-18, GND
25-31,42
Use Matrox cable DBHD44-TO-8BNC to interface with this connector. It has
eight BNC connectors and a high-density 44-pin D-Subminiature male
connector. This cable allows you to attach up to six video sources, an analog sync,
and a trigger input.
Board input and output connectors
Description
GREEN Analog Video Input (Channel 2).
BLUE Analog Video Input (Channel 2).
Opto-Isolated trigger positive input.
Opto-Isolated trigger negative input.
Non-Protected TTL trigger input.
Clock input (TTL).
Clock output (TTL).
Vsync input or output (TTL).
Hsync input or output (TTL).
Exposure #1 output (TTL).
Exposure #2 output (TTL).
Transmit (RS-232).
Receive (RS-232).
CTS (RS-232).
RTS (RS-232).
Auxiliary User Input #1 (positive).
Auxiliary User Input #1 (negative).
Auxiliary User Input #2 (positive).
Auxiliary User Input #2 (negative).
Auxiliary User Output #1 (TTL).
Auxiliary User Output #2 (TTL).
+12 V OR +5 V Power Supply.
Not connected.
Ground.
47