Instructions For Lubrication - Husqvarna SM 610 Workshop Manual

COMPONENT
- Flywheel - crankshaft cone
- Crank mechanism
- Crankshaft - Engine crankcase
- Cylinder head cover-Cylinder head
- Rocker arms-Cylinder head cover
- Crankcase surfaces
- Spring for gearshift
- Piston rings
- Intake manifold-Cylinder head (without O-Ring)
- Clutch control lever
LUBRICATING POINTS
- Roller bearing - Connecting rod small end pin
- Piston - Cylinder liner
- Intake and exhaust valve
- Timing shaft cam
- Rocker arm pivots
- Stud bolts-Nuts
- Cylinder head nuts
- Clutch disc housing bush
- Gears-Shafts
- "O" Rings
- Clutch control pin
- Steel on steel couplings inside the gearbox
- Seal rings
- Clutch control shaft
- Piston pin-Connecting rod small end
Part. N. 8000 A7918 (02-2007)
RIMONTAGGIO MOTORE
ENGINE REASSEMBLY
RÉCOMPOSITION MOTEUR
WIEDERZUSAMMENBAU DES MOTORS
REENSEMBLAJE MOTOR
INSTRUCTIONS FOR ASSEMBLY AND LUBRICATION
Instructions for assembly
PROCEDURE
Degrease with solvent
Mount with engine oil
Insert the crankshaft into the bearings
"Loctite 510" liquid gasket (Pianermetic)
Fit the shim for an axial play of 0.1÷0.3 mm
Glue the two half-carnkcase with "Loctite 510" liquid gasket (Pianermetic)
Fit it with the opening towards the engine center
See page H.25
Fit using "RHODORSEAL" seal
See page D.23

Instructions for lubrication

LUBRICANT
Engine oil
Spray with Engine oil
Engine oil
Engine oil
Engine oil
Engine oil
Grease
Engine oil
Engine oil
Grease
Engine oil
Engine oil
Grease
Engine oil
Engine oil
H.41