Advertisement
IMPIANTO ELETTRICO, STRUMENTO DIGITALE, IMPIANTO INIEZIONE CARBURANTE
ELCTRIC SYSTEM, DIGITAL INSTRUMENT, FUEL INJECTION SYSTEM
INSTALLATION ÉLECTRIQUE, INSTRUMENT DIGITAL, SYSTÈME DE INJECTION CARBURANT
ELEKTRISCHE ANLAGE, DIGITAL INSTRUMENTE, EINSPRITZUNG ANLAGE
SISTEMA ELÉCTRICO, INSTRUMENTO DIGITAL, SISTEMA INYECCIÓN GASOLINA
Instrument setup
This operation allows to set the parameters in order to use the instru-
ment on motorcycles having different characteristics (SM-TE).
1- With instrument OFF, push the MODE knob (1, figure 1) and maintain
it pushed;
2- turn the ignition key on IGNITION position; after approx. 7" WS
appears on the display, R.H. lower side (figure 2);
3- maintaining the MODE knob pushed, push and release the "passing"
control 5 times;
4- releasing the MODE knob the code "0001" appears, which is related
to the SM model (see figure 3);
5- briefly pushing the MODE knob the code "0002" appears, which is
related to the TE model and then "cu" (see figure 4);
6- after the identification of the select code ("0001" for SM and "0002"
for TE), push the MODE knob until WS appears; now releasing the
MODE knob "Ln" appears, showing the first of the 5 pre-selected
values, which cannot be changed, indicated on figures 5 to 9;
7- briefly push the MODE knob in order to see the pre-selected values:
Ln= wheel rolling circumference (mm),
di= wheel diameter (mm),
SPEED= number of pulses per wheel revolutions,
rpm= number of pulses per engine revolutions,
max= runaway speed rate limit;
8- briefly push the MODE knob in order to visualize "km/h- mph" modes
shown on figure 10, then push the MODE knob until the horizontal LED
indicators appear. By releasing the MODE knob only a flashing
measurement unit will appear; this is the measurement unit that will be
active at that time (i.e. km/h: briefly pushing the MODE knob "km/h" will
be replaced with "mph"). In order to confirm the selected measurement
unit, push the MODE knob until "WS" appears.
9- briefly push the MODE knob in order to see the selecting mode
"remaining hours before the engine oil replacement" see figure 11 (first
replacement after 13 hours); push the MODE knob until the horizontal
LED indicators appear. By releasing the MODE knob, instead of the
horizontal LED indicators, "0000" will appear or the previously selected
value, with the flashing first L.H. number. Briefly pushing the MODE
knob, the number advances by a unit, leaving inactive the MODE knob
for 2 seconds the 2nd number on the L.H. side will oscillate. After
having inserted the value, wait for 2" until the number disappears. If the
operation is repeated, the selected number can be modified. If a value
of 000 is planned, the icon will be deactivated;
10- briefly push the MODE knob in order to see the selecting mode
"remaining hours or km before the coupon" (see figure 12), push the
MODE knob until the horizontal LED indicators appear; upon release
figure 13 appears, briefly pushing the MODE knob makes km/h and
CLK appear alternatively. In order to confirm the selected measurement
unit, push the MODE knob and maintain it pushed until shortly after WS
appears on the display, R.H. lower side; upon release of the MODE
knob insert and save the value using the same method shown at point
9. If a value of 000 is planned, the icon will be deactivated. After this
operation, figure 12 will appear. Briefly push the MODE knob making the
text End appear.
Part. N. 8000 A7918 (02-2007)
M.43
Hide quick links:
Advertisement
Chapters
