Flash; Group Call Pickup - NEC DS1000 Quick Setup Manual

Section 2: Customizing Features

Flash

Extension users can access certain CO and PBX features (such as the telephone company's Call
Waiting) by interrupting trunk loop current.
Flash allows an extension user to access certain telephone company and PBX features by interrupting trunk
loop current. Flash lets an extension user take full advantage of whatever features the connected telco or
PBX offers. You must set the Flash parameters for compatibility with the connected telephone company or
PBX. By default, the Flash interval is 800 mS (.8 seconds).
Programming
To change the Flash interval:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 0402 + HOLD . You see:
0402:TRUNK TIMERS
CAMP-ON?nn
3. Press VOL Up until you see:
0402:TRUNK TIMERS
FLASH PBX
4. Enter the new Flash value (in milliseconds) + Hold .
5. Press CONF to exit program 0402.
Feature Quick Steps
1. Press FLASH (if applicable)

Group Call Pickup

Easily answer a call ringing your Pickup Group, even if you don't know which extension is ringing.
Group Call Pickup allows an extension user to answer a call ringing an extension in their assigned Pickup
Group. This permits co-workers in the same Pickup Group to easily "cover" each other's ringing calls. The user
can intercept the ringing call by dialing a code or pressing a programmed Group Call Pickup key. The system
has a maximum of 8 Pickup Groups, with an unlimited number of extensions in each group. However, an exten-
sion can be a member of only one pickup group. By default, the system has no Pickup Groups programmed.
Group Call Pickup can answer the following types of calls:
● Ringing Intercom calls
● Transferred calls
● Direct Inward Lines
● Calls on trunks assigned to the Pickup Group
To simplify picking up calls, an extension can have Programmable Function Keys assigned as Group Call
Pickup keys. There are three types of Group Call Pickup keys: immediate ring, no ring (lamp only) or
delayed ring.
Programming
There are 2 steps to setting up a Group Call Pickup:
●
Part I: Assign extensions to Pickup Groups.
● Part II: Assign Group Call Pickup Keys to extensions.
Part I: Assign Extensions to Pickup Groups:
1. Enter 1802 + HOLD . You see:
1802:EXT OPT PART I
EXTENSION #?nnn
2-18 ◆ Section 2: Customizing Features
+
Dial the code for the desired CO/PBX feature.
DS1000/2000 Quick Setup Guide