Setting A Trunk's Circuit Type; Programming Ringing; Changing Ringing Assignments Using The System Programming - NEC DS1000 Quick Setup Manual

Setting a Trunk's Circuit Type

To set a trunk's circuit type:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1001:TRK DESCRIPTION
TRUNK PORT?n
3. Enter the number of the trunk you want to program (1-6 in DS1000, 1-64 in DS2000) +
1001:TRUNK PORT:n
TYPE?nnnn nnnnnn nn
4. Enter the trunk circuit type (
1001:TRUNK PORT:n
TYPE?(your selection)
ment CD that came with your system.
5. Enter a different circuit type for the trunk (if you made a mistake).
Press
Press

Programming Ringing

In DS1000 by default:
● Trunks 1-6 appear and ring on line keys 1-6 on every keyset. In addition, line keys ring for each incom-
ing call on that key. This means that every keyset rings for each incoming call.
●
Single line telephones also ring for each incoming trunk call.
In DS2000 by default:
●
Trunks 1-12 appear and ring on line keys 1-12 for extensions 300-315. All other extensions are lamp-
only for trunks 1-12 on line keys 1-12.
● Trunks 13-64 do not appear on line keys.
● Single line telephones do not ring for incoming trunk calls.
There are two ways to change the ringing assignments: using the system programming or the User Program-
mable Features.

Changing Ringing Assignments Using the System Programming

To change ringing:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1805:RING ASSIGNMENT
EXTENSION #?nnn
3. Enter the number of the extension you want to program +
1805:EXT:nnn
LINE NUMBER?n
DS1000/2000 Quick Setup Guide
+ . You see:
1001 HOLD
0 =uninstalled,
For additional T1 circuit types, see T1 Trunking in the Software Manual on the System Docu-
OR
CONF to select another trunk.
OR
CONF twice to exit program 1001.
1805 + HOLD . You see:
Section 1: Start-up Programming
51 =loop start DTMF,
HOLD
Section 1: Start-up Programming ◆ 1-7
HOLD
52 =loop start DP) + HOLD
. You see:
1
. You see:
. You see: