NEC DS1000 Quick Setup Manual page 32

Section 2: Customizing Features
Part IV: To enable Caller ID Logging, assign the Caller ID Outbound Line/Group and the sys-
tem's Home Area Code (HNPA).
Setting up the Caller ID Outbound Line/Group
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1302 + HOLD . You see:
1302:CID DIALING
LINE/GROUP:
3. Enter the trunk number (1-6 in DS1000 or 1-64 in DS2000) or Trunk Group (90-98) + HOLD .
4. Press CONF to exit program 1302.
Specify the System's Home Area Code
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1303 + HOLD . You see:
1303:HNPA CODES
EDIT-E/INIT-I
3. Dial 4 (I) + 9 (Y) to initialize the HNPA table. You see:
1303:HNPA CODES
EDIT-E/INIT-I
4. Dial 3 (E) + 2 (A) to enter the HNPA table edit mode. You see:
1303:ADD CODES
DATA?
5. Enter your home area code (e.g., 203) + HOLD . You see:
1303:HNPA TBL(?=CHK)
nnn
6. Press HOLD again, then CONF to exit program 1303.
2-8 ◆ Section 2: Customizing Features
To set up additional Caller ID Logging options, refer to the Caller ID Logging feature in the
Software Manual on the System Document CD that came with your system.
The is the area code in which the system is installed.
Your HNPA entry displays.
DS1000/2000 Quick Setup Guide