Programming Parameters; Setting The Password; Modifying Parameters - Beretta EXCLUSIVE GREEN HE C.S.I. Installer And User Manual

EXCLUSIVE GREEN HE C.S.I. - R.S.I.
2) Viewing just the symbol (Fig. C)
Press the button to reset the appliance. If the boiler starts the ignition
phase and resumes normal operation, it may have stopped by accident.
If these stoppages should continue, contact the Technical Assistance Centre.
3) Viewing the and symbols (Fig. D)
Contact the Technical Assistance Centre.
Note (C.S.I.)
Fault in domestic hot water circuit sensor - 60: the boiler works regularly but
does not ensure the stability of the hot water temperature which, however,
is delivered at a temperature of approximately 50°C. The fault code is only
displayed in standby.

15 - PROGRAMMING PARAMETERS

This boiler incorporates a new generation of electronic boards that, by setting/
modifying operating parameters, allow the boiler to be personalised to satisfy
various system and/or user requirements. The programmable parameters are
shown in the table on the next page.
The parameters must be programmed with the boiler in the OFF position.
To do this, press the button until the display shows "- -" (Fig. E).
During parameter modification operations, the "select functions" button
acts as an ENTER (confirm) button, the
(escape) button. If no confirmation is given within 10 seconds, the value
is discarded and returns to the previously set one.
B
Temporary
fault
Permanent
fault
C
D
20

Setting the password

Press and hold down the select functions button and the
for about 10 seconds. The display will look like Fig. F. Enter the password for
accessing the parameter modifications function by turning the domestic hot
water temperature selector to obtain the required value. The password for
accessing the parameter programming function is located on the back side
of the control panel. Confirm by pressing ENTER.

Modifying parameters

Turn the domestic hot water temperature selector (Fig. G) to sequentially
scroll the two-figure codes of the parameters indicated in the table. After
identifying the parameter you wish to modify, proceed as follows:
- press ENTER to access the parameter modification function.When ENTER
- turn the domestic hot water temperature selector to change the value
- press ENTER to confirm the new value. The digits stop flashing
- press ESCAPE to exit.
The boiler returns to the "- -" (OFF) status.
To reset, press the
button acts as an ESCAPE
is pressed, the previously set value starts flashing (Fig.H)
button (Fig. E).
E
F
G
H
button together