Table of Contents
Advertisement
EXCLUSIVE GREEN HE C.S.I. - R.S.I.
2) Viewing just the
symbol (Fig. C)
Press the
button to reset the appliance. If the boiler starts the ignition
phase and resumes normal operation, it may have stopped by accident.
If these stoppages should continue, contact the Technical Assistance Centre.
3) Viewing the
and
symbols (Fig. D)
Contact the Technical Assistance Centre.
Note (C.S.I.)
&AULT IN DOMESTIC HOT WATER CIRCUIT SENSOR - 6o: THE BOILER WORKS REGULARLY BUT
does not ensure the stability of the hot water temperature which, however,
IS DELIVERED AT A TEMPERATURE OF APPROXIMATELY 5o—#. 4HE FAULT CODE IS
ONLY
displayed in standby.
13 - PROGRAMMING PARAMETERS
This boiler incorporates a new generation of electronic boards that, by setting/
modifying operating parameters, allow the boiler to be personalised to satisfy
various system and/or user requirements.The programmable parameters are
shown in the table on the next page.
4HE PARAMETERS MUST BE PROGRAMMED WITH THE BOILER IN THE /&& POSITION.
To do this, press the
BUTTON UNTIL THE DISPLAY SHOWS h- -v (&IG. %).
During parameter modification operations, the "select functions" button
acts as an ENTER (confirm) button, the button acts as an ESCAPE
(escape) button. If no confirmation is given within 10 seconds, the value
is discarded and returns to the previously set one.
Temporary
fault
Permanent
fault
16
15
Setting the password
Press and hold down the select functions button and the
FOR ABOUT 1o SECONDS. 4HE DISPLAY WILL LOOK LIKE &IG. &. %NTER THE PASSWORD FOR
accessing the parameter modifications function by turning the domestic hot
water temperature selector to obtain the required value. The password for
accessing the parameter programming function is located on the back side
of the control panel. Confirm by pressing ENTER.
Modifying parameters
4URN THE DOMESTIC HOT WATER TEMPERATURE SELECTOR (&IG. ') TO SEQUENTIALLY
scroll the two-figure codes of the parameters indicated in the table. After
identifying the parameter you wish to modify, proceed as follows:
- PRESS %.4%2 TO ACCESS THE PARAMETER MODIlCATION FUNCTION. 7HEN %.4%2
IS PRESSED, THE PREVIOUSLY SET VALUE STARTS mASHING (&IG.()
- turn the domestic hot water temperature selector to change the value
- press ENTER to confirm the new value. The digits stop flashing
- press ESCAPE to exit.
4HE BOILER RETURNS TO THE h- -v (/&&) STATUS.
To reset, press the
BUTTON (&IG. %).
E
F
G
button together
Hide quick links:
Advertisement
Table of Contents
