Switch And Breaker Panel - Pro-Line Boats 29 Grand Sport Owner's Manual

A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.

Switch and Breaker Panel

The switch and breaker panel is located on the console. The numbers shown above each switch in the
photo below correspond with the following descriptions provided for each switch:
Circuit Breakers – On the switch panel below the individual switches
1 2
1 Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore.
Depress the horn switch to the up or forward position to activate the horn. Release the horn
switch to deactivate the horn. Using different sequences of horn blasts indicates different and
sometimes dangerous situations to you or someone around you.
Avoid any horn use without an appropriate purpose. See the Safety Section in this manual
and/or take a safe boating course for more information on the proper use of the horn.
2 Navigation & Anchor/All Around Lights - Locate the Nav. light switch on the instrument panel.
This is a 3-way switch (forward, middle, back/aft) that functions as follows when you press the
switch:

Forward position - Turns on the bow lights and the anchor/all around light. This
position will also activate the red light in your compass.
o
o

Middle position – All lights are off.

Back/Aft position – Anchor/all around light is on; the bow lights and gauge lights
are off.
3 4 5 6
If you have Faria gauges on the dash panel, this function will
illuminate the gauge lights.
If the gauges were provided by the engine manufacturer (i.e.,
Mercury, Honda, etc.), this switch will not illuminate the gauge
lights. Instead, your gauge lights will be illuminated when the
ignition switch is turned on.
7 8 9 10 11 12 13
17