Table of Contents
Advertisement
SATA (Serial ATA) Connector
SATA Power
1
4
Features
•
1 Serial ATA port
- SATA port 0 with data transfer rate up to 3Gb/s
•
Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connector is used to connect the Serial ATA device. Connect one end of the Se-
rial ATA data cable to a SATA connector on the system board and the other end to your Serial
ATA device.
The power cable must be connected from the system board's Serial ATA power connector to
the SATA drive's power connector in order to provide power to the drive.
Connect to the Serial ATA
power connector
Connect to the Serial ATA
port
BIOS Setting
Configure the Serial ATA drives in the Integrated Peripherals submenu ("OnChip IDE Device"
section) of the BIOS. Refer to chapter 7 for more information.
Chapter 5 Ports and Connectors
Chapter 5
Front Audio Connector
Line OUT-JD
Key
7
Mic-JD
GND
NC
RXP
GND
RXN
GND
TXN
TXP
GND
1
SATA 0
SATA 2.0 3Gb/s
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
Connect to the SATA drive
24
10
9
Line OUT-L
GND
Line OUT-R
Mic IN-R
Mic IN-L
2
1
www.dfi .com
Advertisement
Table of Contents
