Chassis Intrusion Connector; Standby Power Led - DFI ES520-CD User Manual

Chassis Intrusion Connector

The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
MyGuard Hardware Monitor
Install the "MyGuard Hardware Monitor" utility. By default, the chassis intrusion detection func-
tion is disabled. When enabled, a warning message will appear when the chassis is open. The
utility can also be configured so that a beeping alarm will sound when the chassis is open.
Refer to the "MyGuard Hardware Monitor" section in chapter 4 for more information.
Chapter 5 Ports and Connectors
Chapter 5
Ground
1
2
Signal
25

Standby Power LED

This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Standby Power LED
www.dfi .com