Table of Contents
Advertisement
USB Configuration
This section is used to configure USB.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
USB Confi guration
USB Devices:
1 Keyboard, 1 mouse
Legacy USB Support
[Enabled]
EHCI Hand-off
[Enabled]
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Legacy USB Support
Enabled
Enables legacy USB.
Auto
Disables support for legacy when no USB devices are connected.
Disabled
Keeps USB devices available only for EFI applications.
EHCI Hand-off
This is a workaround for OSes that does not support EHCI hand-off. The EHCI owner-
ship change should be claimed by the EHCI driver.
Chapter 7 BIOS Setup
Chapter 7
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Enables Legacy USB
support. AUTO option
disables legacy support if
no USB devices are
connected. DISABLE
option will keep USB
devices available only for
EFI applications.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Exit
ESC: Exit
34
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Super IO Confi guration
Super IO Chip
F81866
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Serial Port 3 Confi guration
Serial Port 4 Confi guration
Serial Port 5 Confi guration
Serial Port 6 Confi guration
Restore AC Power Loss
[Turns Off]
Case Open Beep
[Disabled]
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Restore AC Power Lost
Off
When power returns after an AC power failure, the system's power is off. You must
press the Power button to power-on the system.
On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state
where you left off before power failure occurs. If the system's power is off when AC
power failure occurs, it will remain off when power returns. If the system's power is on
when AC power failure occurs, the system will power-on when power returns.
Case Open Beep
Set this fi eld to Enabled to allow the system to alert you of a chassis intrusion event.
Set Parameters of Serial
Port 1 (COMA).
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Exit
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
