Connecting To The Power Supply - JUKI DX-2000QVP Instruction Manual

Connecting to the power supply

Power switch
Machine receptacle
Power switch
Foot-controller-
jack
8
• Disconnect the plug and turn off the power switch (turn
* Be aware that the presser foot comes down automatical-
OFF
ON
Plug
Plug
Foot-controller-plug
Foot controller
WARNING
to "O") that always sewing machine is not to use.
ly if you turn the power ON with the presser foot lifted.
Operating power switch:
Turn OFF the machine, set the power switch to "0"
Turn ON the machine, set the power switch to "I"
WARNING (For U.S.A.,Canada only)
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Not-using foot-controller that using start/stop-
button:
1. Turn OFF the power switch (turn to "O")
2. Insert cord-connector into machine-socket-inlet.
3. Insert plug into socket-outlet.
4. Turn ON the power switch. (Turn to "I")
Using the foot-controller:
1. Turn OFF the power switch (turn to "O")
2. Insert the foot-controller-plug into the foot-controller-jack.
3. Insert cord-connector into machine-socket-inlet.
4. Insert plug into socket-outlet.
5. Turn ON the power switch. (Turn to "I")
* When the foot controller is plugged in, the start/stop but-
ton cannot be used to start sewing.
Start button: Can not operate to start sewing.
Stop button: Can operate to stop sewing.