JUKI DX-2000QVP Instruction Manual page 77

Tips
● How to lock stitches
1. At sewing start, pull up the bobbin thread on the top layer of the fabric, hold both needle and bobbin
threads together and sew 3 stitches on the same point. After that move fabrics as you wish.
In this way, stitches on the wrong side of the fabrics look neat.
2. At sewing-end sew 3 stitches on the same point and stop.
● How to sew stitches with the same stitch length
1. When the foot controller is used, the fabrics can be guided by both hands and you can move the fabrics
freely.
2. Set the speed controller to medium or medium low first, press the foot controller completely and move the
fabrics.
-- if stitches become too large, set the speed controller to "faster"
-- if stitches become too small, set the speed controller to "slower".
4
5
Screw
1 mm
6
7
Place the fabric underneath the presser
foot and lower the presser foot.
Adjust the presser foot height according
to the material thickness.
The height can be adjusted in two different ways.
① In the case of free motion (Pattern No. Quilting 1),
the presser foot height for the float function can
be adjusted with the stitch length adjusting dial.
Height
decreases
② Adjusting with the presser foot screw.
The material can be moved smoothly with no resistance
by adjusting the presser foot height to about 1 mm
above the material.
Use both hands to hold the fabrics and
move it without letting it loose.
The target stitch length is about 1.5 ~ 2.0
mm.
When free motion sewing is finished,
move the drop feed knob back to the left
side.
The feed dog will be up and engaged at the same time
as the machine starts to sew.
Height
increases
75