JUKI DX-2000QVP Instruction Manual page 51

Marking
Needle
thread
Start from here
4
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through
the hole on the presser foot and pull it out sideways.
Place the fabric under the presser foot, align the mark-
ing with the sewing-start point. Penetrate the needle
Hole on the
presser foot
into the fabric by turning the hand wheel and lower the
presser foot.
Sewing-
start point
5
Start sewing.
The machine will stop automatically after sewing the
buttonhole.
* If a buttonhole of the same size will be sewn
again, push the thread trimming button to trim
the threads and raise the presser foot.
Under this condition move to another point,
lower the presser foot and then start sewing.
* Do not change stitch length and/or zigzag width
during buttonholing. Otherwise this will cause
imbalanced stitches.
* If thread trimming button is pushed while sew-
ing buttonhole, the machine will stop and will
not complete the buttonhole.
* Depending on material to be sewn and weaving di-
rection of the material, there might be a slight differ-
ence in zigzag widths between right and left lines of
buttonholes. Test sewing is recommended.
49