Changeover Of Needle Holes (Straight Stitch Slide Plate) - JUKI DX-2000QVP Instruction Manual

Changeover of needle holes (straight stitch slide plate)

How to use the straight
stitch slide plate
1 Needle hole for straight stitches
Straight stitch
slide plate
2 Normal needle hole
Patterns which can be used
with the straight stitch
selection
Do not turn the handwheel by hand when using the
needle hole for straight stitches. Be aware that the
needle can come in contact with the straight stitch
slide plate if you turn the handwheel by hand.
* Change the needle hole from the needle for straight
stitches to the normal needle hole before turning the
power OFF.
It is possible to change the needle hole between the needle
hole for straight stitches and the normal needle hole without
changing the throat plate.
In the case of starting sewing from the edge of material, the
material can be smoothly sewn without being pulled into the
1
needle hole by using the needle hole for straight stitches.
It is possible to change the needle hole to be used only by
changing over the lever position.
Lever
1
2
* When a pattern other than those which can be sewn with
2
After you have changed the needle hole to the needle hole for
straight stitches, press
be used.
Select a pattern with
confirm the pattern.
Attention
Lift the needle and the presser foot.
1 By moving the lever to the left: The
needle hole for straight stitches is
selected.
2 By moving the lever to the right while
slightly pushing it away from you: The
normal needle hole is selected.
the straight stitch selection is selected, the needle hole
for straight stitches cannot be used.
If a pattern other than the straight stitch selection is se-
lected when the needle hole for straight stitches is select-
ed, will be displayed on the screen.
1. The screen will be restored to the normal one by re-
turning the lever to the right.
2. The screen will be changed over to the Direct 1 when
is pressed.
to display the patterns that can
or and press to
31