Table of Contents
Advertisement
Failure to set the modem, and any communications software
used with the modem, to the values shown above will result in
the modem being operated in a non-compliant manner.
Consequently, there would be no permit in force for this
equipment, and the Telecommunications Act 1991 prescribes a
penalty of $12,000 for the connection of non-permitted
equipment.
For Voice Modems:
"Distortion may be generated because of low bit rate voice, and
reduced voice quality may result."
"WARNING: For safety reasons, only connect AUSTEL
permitted or AUSTEL certified equipment."
Refer to the applicable MultiModemII Owner's Manual for
additional information.
Protection Against Contact with TNV Circuit (Internal
PC Cards)
The protective cover is fastened to the modem card by means
that will only allow a tool to remove the cover. "Warning:
removal of the protective cover will render the AUSTEL permit
void."
New Zealand Telecom Warning Notice
"Use of pulse dialing, when this equipment is connected to the same line as
other equipment, may give rise to "bell tinkle" or noise and may also cause a
false answer condition. Should such problems occur, the user should NOT
contact the Telecom Faults Service."
"The preferred method of dialing is to use DTMF tones, as this is faster than
pulse (decadic) dialing and is readily available on almost all New Zealand
telephone exchanges."
"WARNING NOTICE:
during a mains power failure".
MT5634ZPW-PCI
re to set the modem, and any communications
No '111' or other calls can be made from this device
Appendices
89
Advertisement
Table of Contents
