Multitech MultiModem MT5634ZPW-PCI Owner's Manual page 45

&W n Store Current Configuration
Command:
Values:
Default:
Description: &W0
&Y n
Command:
Values:
Default:
Description: &Y0
&Y1
Command: &Z n = x Store Telephone Number
Values:
Default:
Description:
Command: \G n
Values:
Default:
Description: \G0
\G1
Command: \J n
Values:
Default:
Description: \J0
\J1
Command: \K n
Values:
Default:
Description: \K5
MT5634ZPW-PCI
3 AT Commands, S-Registers and Result Codes
n = 0
None
Store active modem settings in NVRAM; load them at
power-on or following the ATZ command instead of
loading the factory defaults from ROM.
Select Stored Configuration for Hard Reset
n = 0
0
Select stored configuration 0 on power-up. (For
backward compatibility with some software.)
Not supported—responds ERROR.
n = 0, 1, 2, or 3
x = Dialing string
None
Stores telephone dial string x in memory location n .
Dial the stored number using the command ATDS=n .
Modem Port Flow Control
n = 0
0
Returns an OK for backward compatibility with some
software.
Not supported—responds ERROR.
Data Buffer Control
n = 0
0
Enable data buffer—serial port speed is independent
of connect speed.
Not supported—responds ERROR.
Set Break Control
n = 5
5
Modem sends break signal received from the DTE to
the remote modem.
45