Multitech MultiModem MT5634ZPW-PCI Owner's Manual page 39

DS= n Dial Stored Telephone Number
Command:
Values:
Default:
Description:
E n
Command:
Values:
Default:
Description: E0
E1
F n
Command:
Values:
Default:
Description: F0
F1
Command: H n
Values:
Default:
Description: H0
H1
MT5634ZPW-PCI
3 AT Commands, S-Registers and Result Codes
S Dial a telephone number previously stored using
the &Zn=x command (see &Zn=x command for
further information). The range of n is 0-3.
, Pause during dialing for time set in register S8.
; Return to command mode after dialing. (Place at
end of dial string.)
! Hook flash. Causes the modem to go on-hook for
one-half second, then off-hook again.
@ Wait for quiet answer. Causes modem to wait for a
ringback, then 5 seconds of silence, before
processing next part of command. If silence is not
detected, the modem returns a NO ANSWER code.
$ AT&T's "call card" tones detection.
^ Disable data calling tone transmission.
n = 0–3
none
Dial a number previously stored in directory number n
by the &Zn=x command .
Example: ATDS=3
Echo Command Mode Characters
n = 0 or 1
1
Do not echo keyboard input to the terminal.
Do echo keyboard input to the terminal.
Echo Online Data Characters
n = 1
1
Enable online data character echo. (Not supported.)
Disable online data character echo (included for
backward compatibility with some software).
Hook Control
n = 0 or 1
0
Go on-hook to hang up.
Go off-hook to make the phone line busy.
39