Multitech MultiModem MT5634ZPW-PCI Owner's Manual page 38

Owner's Manual
Command: A/
Values:
Description:
Command: B n
Values:
Default:
Description: B0
B1
B2
B3
B15
B16
Command: C n
Values:
Default:
Description: C0
C1
D s
Command:
Values:
Default:
Description:
38
Repeat Last Command
n/a
Repeat the last command string. Do not precede this
command with AT. Do not press ENTER to execute.
Communication Standard Setting
n = 0–3, 15, 16
1 and 16
Select ITU-T V.22 mode when modem is at 1200 bps.
Select Bell 212A when modem is at 1200 bps.
Deselect V.23 reverse channel (same as B3).
Deselect V.23 reverse channel (same as B2).
Select V.21 when the modem is at 300 bps.
Select Bell 103J when the modem is at 300 bps.
Carrier Control
n = 1
1
Transmit carrier always off. (Not supported.)
Normal transmit carrier switching (included for
backward compatibility with some software).
Dial
s = dial string (phone number and dial modifiers)
none
Dial telephone number s , where s may up to 40
characters long and include the 0–9, *, #, A, B, C,
and D characters, and the L, P, T, V, W, S, comma
(,), semicolon (;), !, @, ^ and $ dial string modifiers.
Dial string modifiers:
L Redial last number. (Must be placed immediately
after ATD.)
P Pulse-dial following numbers in command .
T Tone-dial following numbers in command (default).
V Switch to speakerphone mode and dial the
following number. Use ATH command to hang up.
W Wait for a new dial tone before continuing to dial.
(X2, X4, X5, X6, or X7 must be selected.)
MT5634ZPW-PCI